DTC P0604 Internal Control Module Random Access Memory (Ram) Error: Notes
WARNING: This page is about a different variant/trim than selected.
DTC detecting condition:
Immediately at fault recognition
Trouble symptom:
- Engine does not start.
- Engine stalls.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Clear Memory Mode>OPERATION
. and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Inspection Mode>PROCEDURE
.
- CHECK FOR ANY OTHER DTC ON DISPLAY
.
Is any other DTC displayed?
- Yes: Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>List of Diagnostic Trouble Code (DTC) .
- No: Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis.NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.