Execution Condition
WARNING: This page is about a different variant/trim than selected.
| Secondary Parameters | Execution condition | ||
|---|---|---|---|
| (Evaporative Leak Check Module switching valve for time) | = Close < 120000ms |
||
| Purge control duty ratio | > 0% | ||
| Preconditions (The condition is to close the intrusive Evaporative Leak Check Module switching valve) Battery voltage value |
≥ 10.9 V | ||
| Barometric pressure | ≥ 75.1kPa (563mmHg, 22.2inHg) | ||
| Integrated value of calculated purge airflow since engine start | ≥ 72g (2.54oz)(1) | ||
| Barometric pressure - Manifold absolute pressure | ≥ 6.7kPa (50mmHg, 2inHg) | ||
| ((Fuel system status for time) | = Fuel cut ≥ 1000ms |
||
| followed by Fuel system status) | Fuel cut | ||
| Ambient air temperature | ≥ -25°C (-13°F) |
||
|
|||