DTC P0336 Crankshaft Position Sensor "A" Circuit Range/Performance: Notes
WARNING: This page is about a different variant/trim than selected.
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
- Engine stalls.
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Clear Memory Mode>OPERATION
. and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Inspection Mode>PROCEDURE
.
- CHECK CONDITION OF CRANKSHAFT POSITION SENSOR
.
Turn the ignition switch to OFF.
Is the crankshaft position sensor installation bolt tightened securely?
- Yes: Go to 2 .
- No: Tighten the crankshaft position sensor installation bolt securely. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Crankshaft Position Sensor>INSTALLATION .
- CHECK CRANKSHAFT POSITION SENSOR PLATE
.
Is there crack or damage in the crankshaft position sensor plate teeth?
- Yes: Replace the crankshaft position sensor plate. Ref. to MECHANICAL(H4DO)>Cylinder Block .
- No: Go to 3 .
- CHECK INSTALLATION CONDITION OF TIMING CHAIN
.
Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block.
ST 18252AA000 CRANKSHAFT SOCKET
Is the timing chain dislocated from its proper position?
- Yes: Correct the installation condition of timing chain. Ref. to MECHANICAL(H4DO)>Timing Chain Assembly .
- No: Replace the crankshaft position sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Crankshaft Position Sensor .