DTC P0037 A/F/O2 Heater Control Circuit Low Bank 1 Sensor 2: Notes

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Clear Memory Mode . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Inspection Mode .
Use the check board when measuring the ECM terminal voltage and resistance.

Wiring diagram:

Engine Electrical System Ref. to WIRING SYSTEM>Engine Electrical System>WIRING DIAGRAM .

Fig 1: A/F/O2 Heater Control Circuit Low Bank 1 Sensor 2 - Wiring Diagram

Courtesy of SUBARU OF AMERICA, INC.

CHECK POWER SUPPLY TO REAR OXYGEN SENSOR.
1. Turn the ignition switch to OFF.
2. Disconnect the connector from rear oxygen sensor.
3. Turn the ignition switch to ON.
4. Measure the voltage between rear oxygen sensor connector and engine ground.
Connector & terminal

(E25) No. 1 (+) - Engine ground (-):

Is the voltage 10 V or more?
- Yes: Go to 2.
- No: Repair the power supply line. Or replace the main relay.
  NOTE:
  In this case, repair the following item:
  - Open circuit in harness between A/F, oxygen sensor relay connector and rear oxygen sensor connector
  - Poor contact of A/F, oxygen sensor relay connector
  - Poor contact of coupling connector
  - Malfunction of A/F, oxygen sensor relay
CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR.
1. Turn the ignition switch to OFF.
2. Disconnect the connector from ECM.
3. Measure the resistance between ECM connector and oxygen sensor connector.
Connector & terminal

(B135) No. 65 - (E25) No. 2:

Is the resistance less than 1 Ω?
- Yes: Go to 3.
- No: repair the harness and connector.
  NOTE:
  In this case, repair the following item:
  - Open circuit in harness between ECM connector and rear oxygen sensor connector
  - Poor contact of coupling connector
CHECK GROUND CIRCUIT FOR ECM.
Measure the resistance of harness between ECM connector and chassis ground.

Connector & terminal

(B135) No. 61 - Chassis ground:

(B135) No. 62 - Chassis ground:

(B135) No. 63 - Chassis ground:

(B135) No. 64 - Chassis ground:

(B135) No. 65 - Chassis ground:

Is the resistance less than 5 Ω?
- Yes: Go to 4.
- No: repair the harness and connector.
  NOTE:
  In this case, repair the following item:
  - Open circuit of harness between ECM connector and engine ground
  - Poor contact of coupling connector
CHECK REAR OXYGEN SENSOR.
Measure the resistance between rear oxygen sensor terminals.

Terminals

No. 2 -No. 1:

Is the resistance 5 - 6.4 Ω?
- Yes: Repair the poor contact of ECM connector.
- No: Replace the rear oxygen sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Rear Oxygen Sensor .