Execution Condition
WARNING: This page is about a different variant/trim than selected.
| Secondary Parameters | Execution condition |
|---|---|
| Status of each cylinder correction value = Accumulated time since operation started* | ≥ 400time(s) (12.8 sec) |
| (Refer to Table below) *Accumulated time is cumulatively calculated (If the secondary parameter is not satisfied for the status of each cylinder correction value, accumulated time will not be reset) |
Table: Status of each cylinder correction value
| Secondary Parameters | Execution condition |
|---|---|
| Main feedback | In operation |
| Engine speed | ≤ 4000 RPM |
| Engine load | ≥ 0.6 g/rev |
| Amount of intake air | ≥ 10 g/sec |