LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transaxle & Differential) >> Transmission Mounting System >> Removal >> CROSSMEMBER And Cushion Rubber

CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the center exhaust pipe. Ref. to EXHAUST(H4DO)>Center Exhaust Pipe>REMOVAL .
  4. Remove the center exhaust cover.
    Fig 1: Identifying Center Exhaust Cover
    G11267744Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the transmission under cover.
    Fig 2: Identifying Transmission Under Cover
    G09482495Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack.
    CAUTION: Always support the transmission case with a transmission jack.
  7. Remove the front crossmember and the rear crossmember.
    Fig 3: Locating Front Crossmember And Rear Crossmember Bolts
    G06349664Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the transmission cushion rubber.
scientia non olet · About LEMON Manuals