Transfer Drive Gear: Inspection
WARNING: This page is about a different variant/trim than selected.
- Ball bearing
Replace the bearings in the following cases.
- In case of broken or rusty bearings
- In case of worn or damaged bearings
- When the bearings fail to turn smoothly or emit noise in rotation after transmission gear oil has been applied.
- Transfer drive gear
If the drive gear tooth surface and shaft are excessively broken or damaged, replace the drive gear.
- Measure the clearance between snap ring and inner race of ball bearing with a thickness gauge.
Clearance:
0.01-0.15 mm (0.0004-0.0059 in)
Courtesy of SUBARU OF AMERICA, INC.
If the measurement is not within specification, select a suitable snap ring and replace it.
Snap ring (outer-30) Part No. Thickness mm (in) 805030041 1.53 (0.0602) 805030042 1.65 (0.0650) 805030043 1.77 (0.0697)