Differential Case Assembly

WARNING: This page is about a different variant/trim than selected.

Loosen the twelve bolts and remove hypoid driven gear.

Fig 1: Identifying Hypoid Driven Gear
Courtesy of SUBARU OF AMERICA, INC.
Drive out the straight pin from differential assembly toward hypoid driven gear side.
ST 899904100 STRAIGHT PIN REMOVER

Fig 2: Driving Out Straight Pin From Differential Assembly Toward Hypoid Driven Gear Side
Courtesy of SUBARU OF AMERICA, INC.
Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.

Fig 3: Identifying Differential Case Assembly Components
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, remove the taper roller bearing.
ST 899524100 PULLER SET

Fig 4: Removing Taper Roller Bearing Using ST
Courtesy of SUBARU OF AMERICA, INC.