LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (M/T Clutch System) >> General Diagnostic Table >> Inspection >> Diagnostic Diagram Of Clutch Drag

Diagnostic Diagram Of Clutch Drag

WARNING: This page is about a different variant/trim than selected.
  1. CHECK GEAR NOISE. 
    1. Start the engine.
    2. While idling the engine, step on the clutch pedal and quickly shift from neutral to reverse.

    Is there any abnormal noise from the transmission gear?

    1. Yes  : Go to  2.
    2. No  : Clutch is normal.
  2. CHECK GEAR NOISE. 

    Depress the clutch pedal at idle and shift from neutral to reverse within 0.5-1.0 second.

    Is there any abnormal noise from the transmission gear?

    1. Yes  : Go to  3.
    2. No  : Defective transmission or excessive clutch drag torque. Inspect pilot bearing, clutch disc, transmission and clutch disc hub spline.
  3. CHECK GEAR NOISE. 
    1. Depress the clutch pedal at idle and shift from neutral to reverse within 0.5-1.0 second.
    2. While stepping on the clutch pedal, shift from neutral to reverse, reverse to neutral several times.

Is there any abnormal noise from the transmission gear?

  1. Yes  : Inadequate clutch disengage. Inspect the clutch disc, clutch cover, clutch release, and clutch pedal free play.
  2. No  : Clutch and flywheel seizure. Inspect the clutch disc and the spline of the clutch disc hub.
scientia non olet · About LEMON Manuals