DTC P0463 Fuel Level Sensor "A" Circuit High: Notes

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Clear Memory Mode>OPERATION . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Inspection Mode>PROCEDURE .

CHECK FOR ANY OTHER DTC ON DISPLAY.
Is DTC P0462 or P0463 displayed on the Subaru Select Monitor?
- Yes: Perform the diagnosis from step 2 in DTC B1500 of the combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B1500 FUEL SENDER OPEN DETECTED .
- No: Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis.
  NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.