DTC P0336 Crankshaft Position Sensor "A" Circuit Range/Performance: Notes
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
- Engine stalls.
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Clear Memory Mode>OPERATION
. and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Inspection Mode>PROCEDURE
.
- CHECK CONDITION OF CRANKSHAFT POSITION SENSOR.
Turn the ignition switch to OFF.
Is the crankshaft position sensor installation bolt tightened securely?
- Yes: Go to 2.
- No: Tighten the crankshaft position sensor installation bolt securely. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Crankshaft Position Sensor .
- CHECK CRANKSHAFT POSITION SENSOR PLATE.
Is there crack or damage in the crankshaft position sensor plate teeth?
- Yes: Replace the crankshaft position sensor plate. Ref. to MECHANICAL(H4DOTC)>Cylinder Block .
- No: Go to 3.
- CHECK INSTALLATION CONDITION OF TIMING CHAIN.
Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block.
ST 18252AA000 CRANKSHAFT SOCKET
Is the timing chain dislocated from its proper position?
- Yes: Correct the installation condition of timing chain. Ref. to MECHANICAL(H4DOTC)>Timing Chain Assembly .
- No: Replace the crankshaft position sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Crankshaft Position Sensor .