DTC P0123 Throttle/Pedal Position Sensor/Switch "A" Circuit High: Notes

DTC detecting condition: 

Immediately at fault recognition

Trouble symptom: 

• Improper idling
• Engine stalls.
• Poor driving performance
  CAUTION:

  • After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Clear Memory Mode . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Inspection Mode .
  • Use the check board when measuring the ECM terminal voltage and resistance.

Wiring diagram: 

Engine Electrical System Ref. to WIRING SYSTEM>Engine Electrical System>WIRING DIAGRAM .

1. CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR. 
   1. Turn the ignition switch to OFF.
   2. Disconnect the connectors from electronic throttle control.
   3. Disconnect the connector from ECM.
   4. Measure the resistance of harness between ECM and electronic throttle control connector.

      Connector & terminal 

      (E158) No. 17 - (E57) No. 1:

      (E158) No. 30 - (E57) No. 3:

   Is the resistance less than 1 Ω?

   • Yes  : Go to 2. 
   • No  : Repair the open circuit of harness between ECM and electronic throttle control connector.
2. CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR. 
   1. Connect the connector to ECM.
   2. Measure the resistance between electronic throttle control connector and engine ground.

      Connector & terminal 

      (E57) No. 3 - Engine ground:

   Is the resistance less than 5 Ω?

   • Yes  : Go to 3. 
   • No  : repair the harness and connector.
     NOTE: In this case, repair the following item:

     • Open circuit of harness between ECM and engine ground
     • Poor contact of ECM connector
     • Poor contact of coupling connector
3. CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR. 
   1. Turn the ignition switch to ON.
   2. Measure the voltage between electronic throttle control connector and engine ground.

      Connector & terminal 

      (E57) No. 1 (+) - Engine ground (-):

   Is the voltage 5 V or more?

   • Yes  : Repair the short circuit to power in harness between ECM and electronic throttle control connector.
   • No  : Go to 4. 
4. CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR. 
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from ECM.
   3. Measure the resistance between ECM connectors.

      Connector & terminal 

      (E158) No. 17 - (E158) No. 18:

   Is the resistance 1 MΩ or more?

   • Yes  : Repair the poor contact of electronic throttle control connector. Replace the electronic throttle control if defective. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Throttle Body .
   • No  : Repair the short circuit to power in harness between ECM and electronic throttle control connector.