DTC P0038 A/F/O2 Heater Control Circuit High Bank 1 Sensor 2: Notes

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Clear Memory Mode . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Inspection Mode .
Use the check board when measuring the ECM terminal voltage and resistance.

Wiring diagram:

Engine Electrical System Ref. to WIRING SYSTEM>Engine Electrical System>WIRING DIAGRAM .

Fig 1: A/F/O2 Heater Control Circuit High Bank 1 Sensor 2 - Wiring Diagram

G11270524

Courtesy of SUBARU OF AMERICA, INC.

CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR.
1. Turn the ignition switch to OFF.
2. Measure the voltage between ECM and engine ground.
  Connector & terminal
  
  (E159) No. 3 (+) - Engine ground (-):
Is the voltage 10 V or more?
- Yes : Repair the short circuit to power in the harness between ECM and rear oxygen sensor connector.
- No : Go to 2.
CHECK GROUND CIRCUIT FOR ECM.
1. Disconnect the connector from ECM.
2. Measure the resistance between ECM and engine ground.
  Connector & terminal
  
  (B134) No. 35 - Engine ground:
  
  (B134) No. 47 - Engine ground:
  
  (E159) No. 10 - Engine ground:
  
  (E159) No. 17 - Engine ground:
  
  (E159) No. 18 - Engine ground:
  
  (E159) No. 25 - Engine ground:
  
  (E159) No. 26 - Engine ground:
Is the resistance less than 5 Ω?
- Yes : Repair the poor contact of ECM connector.
- No : repair the harness and connector.
  NOTE:
  In this case, repair the following item:
  - Open circuit of harness between ECM and engine ground
  - Poor contact of coupling connector