Active Test: Operation

On [Start] display, select [Diagnosis].
On [Vehicle selection] display, input the target vehicle information and select [OK].
On [Main Menu] display, select [Each System].
On [Select System] display, select [Combination Meter], and then select [Enter].
On [Select Function] display, select [Active Test].
On [Active Test] display, select an item to be checked.
NOTE:
- For detailed operation procedures, refer to "Application help".
- If not equipped (depending on destination area or vehicle equipment condition), process will not go on.
CAUTION: After executing the system operation check mode, make sure to clear memory. Ref. to COMBINATION METER (DIAGNOSTICS)>Clear memory .