LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Steering Switch >> Inspection

Steering Switch: Inspection

  1. Check the resistance between connector terminals.

    Preparation tool: 

    Circuit tester

    Fig 1: Identifying Steering Switch Terminals
    G10272781Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection conditions Standard
    3 - 2 Δ (UP) i/SET (DOWN) All OFF 1 MΩ or more
    Δ (UP) ON Less than 1 Ω
    i/SET ON Approx. 1, 000 Ω
    (DOWN) ON Approx. 3, 670 Ω
  2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
    Terminal No. Inspection conditions Specification
    4 (+) - 1 (-) Apply battery voltage. Light ON
  3. Replace the MID switch if it is found defective.
scientia non olet · About LEMON Manuals