Multi-function Display (MFD): Installation
CAUTION:
- Make sure the electrical connector is connected securely.
- Make sure that the multi-function display (MFD) operates normally.
- After installing the center grille assembly, check that the air vent grille is inserted correctly into the air vent duct.
- When the multi-function display (MFD) has been replaced, perform the following operations.
- Be sure to reset the ODO fuel economy value of the multi-function display (MFD). Ref. to INSTRUMENTATION/DRIVER INFO>Multi-function Display (MFD) System>OPERATION>ODO FUEL ECONOMY VALUE RESET (HIGH GRADE TYPE ONLY) .
- Be sure to correction the lifetime fuel economy value of the multi-function display (MFD). Ref. to INSTRUMENTATION/DRIVER INFO>Multi-function Display (MFD) System>OPERATION>DIAGNOSTIC MODE (HIGH GRADE TYPE ONLY) .
- Install each part in the reverse order of removal.
- Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .