Rear Differential Front Member: Installation

Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.

Fig 1: Identifying Rear Differential Front Member Self Locking Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Tighten the self-locking nut.
Tightening torque:

T1: 50 N.m (5.1 kgf-m, 36.9 ft-lb)

T2: 110 N.m (11.2 kgf-m, 81.1 ft-lb)

Fig 2: Identifying Rear Differential Front Member Self Locking Nuts With Torque Specifications
Courtesy of SUBARU OF AMERICA, INC.