Check With SUBARU Select Monitor

Connect the Subaru Select Monitor to data link connector.
NOTE: For detailed operation procedures, refer to "Application help".
1. On [Start] display, select Diagnosis.
2. On Vehicle selection display, input the target vehicle information and select [OK].
3. On Main Menu display, select [Each System].
4. On [Select System] display, select [Brake Control System], and then select [Next].
5. On [Select Function] display, select [Data Monitor].
6. From the data monitor item list, select [RR Wheel Speed] and [RL Wheel Speed].
Check if the speed indicated on the display changes in the same manner as the speedometer reading during acceleration/deceleration when the steering wheel is in the straight-ahead position.
If the speed indicated on the display does not change in the inspection, check the ABS wheel speed sensor. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>Front ABS Wheel Speed Sensor>INSPECTION>CHECK ABS WHEEL SPEED SENSOR UNIT .