Parking Brake Cable: Installation

Install each part in the reverse order of removal.
CAUTION: Do not reuse the nut (self locking nut). Always replace with a new part.

Tightening torque:

Fuel tank protector: Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Fuel Tank Protector>REMOVAL .

Cable clamp: 18 N.m (1.84 kgf-m, 13.3 ft-lb)

Rear wheel: 120 N.m (12.24 kgf-m, 88.5 ft-lb)
NOTE:
- Apply grease to the cable guide inside the tunnel, and pass the cable through.
- After installing the backrest assembly, make sure that each seat belt operates normally.
- Make sure that they are properly secured on each hook on the vehicle side.
Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
Be sure to adjust the lever stroke. Ref. to PARKING BRAKE>Parking Brake Lever>ADJUSTMENT .