Rear Disc Rotor: Installation

NOTE: Before installation, remove mud and foreign matter from the caliper body assembly.

Before installation, check the rear disc rotor. Ref. to BRAKE>Rear Disc Rotor>INSPECTION .
Install each part in the reverse order of removal.
NOTE: When installing the rear disc rotor, match the alignment mark (a) of the rear disc rotor and the alignment mark (b) of the bolt - hub.

Fig 1: Matching Alignment Mark Of Rear Disc Rotor And Bolt - Hub
Courtesy of SUBARU OF AMERICA, INC.
Adjust the parking brake. Ref. to PARKING BRAKE>Parking Brake Assembly (Rear Disc Brake)>ADJUSTMENT .
Tightening torque:

Brake hose bracket: 33 N.m (3.36 kgf-m, 24.3 ft-lb)

Mounting bolt: 66 N.m (6.73 kgf-m, 48.7 ft-lb)

Rear wheel: 120 N.m (12.24 kgf-m, 88.5 ft-lb)