Brake Pedal: Installation
CAUTION:
Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION
.
- Install each part in the reverse order of removal.CAUTION:
- Apply grease to the snap pin to prevent the operating rod from wear.
- Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin.
Tightening torque:
Brake pedal: 18 N.m (1.84 kgf-m, 13.3 ft-lb)
Knee airbag module: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
- Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
- Check that the brake light operate properly.
- Check the brake pedal after installation. Ref. to BRAKE>Brake Pedal>INSPECTION .