DTC C1412 Selected Parameter: Trouble symptom
- ABS does not operate.
- EBD does not operate.
- VDC does not operate.
- Hill start assist does not operate.
- Hill descent control does not operate. (Model with X mode)
- EyeSight does not operate. (Model with EyeSight)
NOTE:
When the VDCCM or VDCCM&H/U is replaced, this DTC may be stored.
- CHECK VDCCM&H/U IDENTIFICATION SYMBOL.
Check the identification symbol attached on the H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>General Description>SPECIFICATION .
Is the identification symbol correct?
- Yes : Go to 2.
- No : Replace the VDCCM&H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) .
- CHECK PARAMETER SELECTED IN VDCCM.
Ref. to BRAKE CONTROL (DIAGNOSTICS)>Subaru Select Monitor>OPERATION>PARAMETER CHECK .
Does the parameter registered in the VDCCM match the relevant vehicle?
- Yes : Replace the VDCCM&H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) .
- No : Select and register the correct parameter. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Subaru Select Monitor>OPERATION>PARAMETER SELECTION .