Passenger's Seat (Model With Auto)

CAUTION: Since the switch - power window sub is controlled by CPU, do not check continuity for switch alone with the circuit tester. Performing continuity check with circuit tester can damage the switch - power window sub circuit.

Check output from the switch - power window sub to the passenger's side motor using the oscilloscope function in the Subaru Select Monitor.

Remove the switch - power window sub.
Connect the battery and the Subaru Select Monitor to the switch - power window sub terminal.
NOTE: For detailed procedures, refer to "Subaru Select Monitor Operation Manual".

Fig 1: Connecting Battery And Subaru Select Monitor To Switch - Power Window Sub Terminal
Courtesy of SUBARU OF AMERICA, INC.

Operate the switch - power window sub and check the output.

NOTE: Since output time during window UP operation is extremely short, it cannot be checked without using a measuring instrument such as oscilloscope.
Output is constantly produced while the switch is operated for window DOWN operation.

Inspection conditions	Output time	Standard
AUTO UP UP	Approx. 130 ms	Battery voltage
OFF	-	0 V
DOWN	During switch operation	Battery voltage
AUTO DOWN	Approx. 300 ms	Battery voltage

If the inspection result is not within the standard, replace the switch - power window sub.