Passenger's Seat

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
The passenger's seat is integrated in the seat cushion pad and frame assembly. Never remove the following parts.
- Occupant detection control module
- Occupant detection sensor
- Frame assembly - front seat cushion
- Pad assembly - front seat cushion
If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.
Never remove the occupant detection sensor connector from the occupant detection control module.
When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.
When removing or replacing the seat cover, perform "Occupant Detection System Inspection" after installing the seat to check if the occupant detection system operates normally. Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>SEAT .
If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part.
If the seat heater module is reused, remove the polyurethane section from the reverse side completely.

Remove the front seat (passenger's side) from vehicle. Ref. to SEATS>Front Seat>REMOVAL .
Refer to the disassembly procedures for the driver's seat. Ref. to SEATS>Front Seat>DISASSEMBLY>MANUAL SEAT .