Cannot Lock/Unlock With Keyless Access From The Passenger's Door

CAUTION:

Check that there are no other registered access keys inside the vehicle.
Inspect LAN system according to the basic diagnostic procedure, and make sure that there is no fault.
Check that the keyless access function is not stopped.
When the access key or keyless access CM is replaced, registration of the immobilizer is required. For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume. Contact an authorized Subaru Dealership.

CHECK DOOR LOCK SWITCH.
Check that the lock/unlock operates with the driver's door lock switch.

Does it lock/unlock normally?
- Yes : Go to 2.
- No : Check the door lock circuit. Ref. to SECURITY AND LOCKS>Door Lock Control System>INSPECTION>SYMPTOM CHART .
CHECK FUSE.
Check the fuse. Ref. to SECURITY AND LOCKS>Relay and Fuse .

Is the check result OK?
- Yes : Go to 3.
- No : Replace the fuse.
CHECK HARNESS (OPEN CIRCUIT).
1. Disconnect the keyless access CM connector.
2. Disconnect the front outer handle connector.
3. Using a tester, measure the resistance between the keyless access CM connector and front outer handle connector, and between front outer handle connector and chassis ground.
  Connector & terminal
  
  (B574) No. 11 - (D56) No. 6:
  
  (B574) No. 10 - (D56) No. 3:
  
  (B574) No. 23 - (D56) No. 4:
  
  (D56) No. 2 - Chassis ground:
Is the resistance less than 1 Ω?
- Yes : Go to 4.
- No : Repair or replace the open circuit of harness.
CHECK HARNESS (GROUND SHORT CIRCUIT).
Using a tester, measure the resistance between the keyless access CM connector and chassis ground.

Connector & terminal

(B574) No. 11 - Chassis ground:

(D56) No. 6 - Chassis ground:

(B574) No. 10 - Chassis ground:

(D56) No. 3 - Chassis ground:

Is the resistance 10 kΩ or more?
- Yes : Go to 5.
- No : Repair or replace the short circuit of the harness.
CHECK KEYLESS ACCESS CM.
1. Connect the keyless access CM connector.
2. Turn the ignition switch to OFF, close all doors and take the access key out of passenger room.
3. Using the Subaru Select Monitor, measure the waveform between the front outer handle connector.
  Connector & terminal
  
  (D56) No. 6 - (D56) No. 3:
Does pulse output change from pulse output OFF → pulse output ON by the lock operation using access key?
- Yes : Go to 6.
- No : Replace the keyless access CM. Ref. to SECURITY AND LOCKS>Keyless Access CM>REMOVAL .
REPLACE FRONT DOOR OUTER HANDLE.
Replace the passenger's side front outer handle with the driver's side front outer handle. Ref. to SECURITY AND LOCKS>Front Outer Handle>REMOVAL .

Does it operate properly?
- Yes : Replace the passenger's front outer handle. Ref. to SECURITY AND LOCKS>Front Outer Handle>REMOVAL .
- No : Replace the keyless access CM. Ref. to SECURITY AND LOCKS>Keyless Access CM>REMOVAL .