Active Test: Operation

On [Start] display, select [Diagnosis].
On [Vehicle selection] display, input the target vehicle information and select [OK].
On [Main Menu] display, select [Each System].
On [Select System] display, select [Keyless Access with Push Button Start], and then select [Enter].
On [Select Function] display, select [Active Test].
Select a location to be inspected.
NOTE: Each output check continues to run for five seconds before stopping automatically.

Data

Keyless access CM output check

Remarks

Tuner power supply ON (indoor tuner)

Output

Perform the power supply check for the receiver.

Stop

Driver's external transmitter

Output

Perform the output check for the driver's side door outside antenna.

Stop

Passenger's external transmitter

Output

Perform the output check for the passenger's side door outside antenna.

Stop

STSW

Output

Turn on the STSW.⁽²⁾2

Stop

IGN2

Output

Turn on the IGN2.

Stop

IGN1

Output

Turn on the IGN1.

Stop

ACC

Output

Turn on the ACC.

Stop

Start SW character illumination lighted

Output

Perform ON output of the push button ignition switch back-up light.⁽¹⁾1

Stop

Start SW indicator lighted (green)

Output

Perform ON output of the push button ignition switch back-up light.⁽¹⁾1

Stop

Start SW indicator lighted (orange)

Output

Perform ON output of the push button ignition switch backup light.⁽¹⁾1

Stop

Steering lock power supply

Output

Output power supply signal from power supply CM to steering lock CM.

Stop

⁽¹⁾	When lit by a condition other than for a system operation check mode, it will not become unlit even when set to either OFF or no output.

⁽²⁾	When performed with IGN ON, engine will start. Therefore, great care must be exercised.

NOTE: For detailed operation procedures, refer to "Application help".