LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Rear Gate System (Diagnostics) >> Diagnostics with Phenomenon >> The Buzzer Does Not Sound >> PRG Position Cannot Be Memorized

PRG Position Cannot Be Memorized

NOTE: Before performing diagnosis, initialize PRG SYS by opening PRG in manual operation, and then operating the power rear gate auto closer from the partially latched state.
  1. CHECK DTC. 

    Using the Subaru Select Monitor, read DTC of PRG CM. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .

    Are any DTCs displayed?

  2. CHECK MEMORY HEIGHT SW. 

    Is the memory height SW ON?

    • Yes: Go to 3. 
    • No: Set the memory height SW to ON.
  3. CHECK EACH SW. 

    Perform inspections in "CHECK PRG INNER SW INPUT CIRCUIT", and "CHECK MEMORY HEIGHT SW INPUT CIRCUIT". Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostics with Phenomenon>INSPECTION>CHECK PRG INNER SW INPUT CIRCUIT . Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostics with Phenomenon>INSPECTION>CHECK MEMORY HEIGHT SWITCH INPUT CIRCUIT .

    Is the check result OK?

    • Yes: Replace the PRG CM. Ref. to REMOVAL .
    • No: Repair it according to each inspection.
scientia non olet · About LEMON Manuals