PRG Inner SW Does Not Function
- CHECK DTC.
Using the Subaru Select Monitor, read DTC of PRG CM. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .
Are any DTCs displayed? (Current malfunction)
- Yes: Perform the diagnosis for the displayed DTCs. Ref. to POWER REAR GATE (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC) .
- No: Go to 2.
- CHECK DATA MONITOR.
Using Subaru Select Monitor, check [R/G inner SW]. Ref. to POWER REAR GATE (DIAGNOSTICS)>Data Monitor .
Does the display switch between OFF ←→ ON according to PRG inner SW operation?
- Yes: Go to 4.
- No: Go to 3.
- CHECK PRG INNER SW INPUT CIRCUIT.
Refer to "CHECK PRG INNER SW INPUT CIRCUIT", and check the PRG inner SW. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostics with Phenomenon>INSPECTION>CHECK PRG INNER SW INPUT CIRCUIT .
Is the check result OK?
- Yes: Go to 4.
- No: Repair according to "CHECK PRG INNER SW INPUT CIRCUIT".
- CHECK POWER REAR GATE AUTO CLOSER.
Refer to step 3 and subsequent procedures for DTC B2513, and check the power rear gate auto closer. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2513 LATCH CONDITION .
Is the check result OK?
- Yes: Go to 5.
- No: Repair it according to B2513 diagnosis.
- CHECK SOLENOID.
Refer to step 4 and subsequent procedures for DTC B2523, and check the solenoid. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2523 HALF STOP SOLENOID FAILURE .
Is the check result OK?
- Yes: Go to 6.
- No: Repair it according to B2523 diagnosis.
- CHECK CLUTCH.
Refer to step 4 and subsequent procedures for DTC B2509, and check the clutch. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2509 CLUTCH OPEN .
Is the check result OK?
- Yes: Go to 7.
- No: Repair it according to B2509 diagnosis.
- CHECK PRG MOTOR OPEN CIRCUIT.
Perform step 4 and subsequent procedures for DTC B2507, and check the PRG motor open circuit. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2507 PRG MOTOR CIRCUIT OPEN .
Is the check result OK?
- Yes: Go to 8.
- No: Repair it according to B2507 diagnosis.
- CHECK PRG MOTOR SHORT.
Perform step 4 and subsequent procedures for DTC B2508, and check the PRG motor short circuit. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2508 PRG MOTOR CIRCUIT LOW .
Is the check result OK?
- Yes: Go to 9.
- No: Repair it according to B2508 diagnosis.
- CHECK ROTATION SENSOR.
Perform step 4 and subsequent procedures for DTC B250B, and check the rotation sensor. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B250B ROTATION SENSOR A STUCK .
Is the check result OK?
- Yes: Go to 10.
- No: Repair it according to B250B diagnosis.
- CHECK TOUCH SENSOR.
Perform step 3 and subsequent procedures for DTC B250A, and check the touch sensor. Ref. to POWER REAR GATE (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B250A TOUCH SENSORS BATT. GND SHORT OUT .
Is the check result OK?
- Yes: Replace the PRG CM. Ref. to REMOVAL .
- No: Repair it according to B250A diagnosis.