Data Monitor: Operation

On [Start] display, select [Diagnosis].
On [Vehicle selection] display, input the target vehicle information and select [OK].
On [Main Menu] display, select [Each System].
On [Select System] display, select [Power Rear Gate], and then select [Enter].
On [Select Function] display, select [Data monitor].
NOTE:
- For detailed operation procedures, refer to "Application help".
- Communication with PRG CM and Subaru Select Monitor takes time. It takes time to show all the items, and the status cannot be reflected on the display. Therefore, select items only that need to be checked or up to two to three items, when checking the status. (When displaying selected items only, place a check mark for the item to be displayed and press the "Select" button.)