LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Security System >> Inspection >> Check Ignition Switch Circuit

Check Ignition Switch Circuit

  1. CHECK CURRENT DATA  .

    Display the data of [Battery Voltage] and [Ignition Power Supply Voltage] using Subaru Select Monitor.

    NOTE: For detailed operation procedures, refer to "Application help".

    Does the [Ignition Power Supply Voltage] indicate 0 V when the ignition is OFF, and fall within a range of ±1 V from the [Battery Voltage] when the ignition is ON?

    1. Yes: The ignition switch input circuit is OK.
    2. No: Go to 2  .
  2. CHECK IGNITION SWITCH CIRCUIT  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the connector of body integrated unit.
    3. Turn the ignition switch to ON.
    4. Measure the voltage between the body integrated unit connector and chassis ground.

      Connector & terminal 

      (B281) No. 3 (+) - Chassis ground (-):

    Is the voltage 10 V or more?

    1. Yes: Check body integrated unit. Ref. to BODY CONTROL(DIAGNOSTICS)>Basic Diagnostic Procedure .
    2. No: Check the harness for open or short circuit between body integrated unit and fuse.
scientia non olet · About LEMON Manuals