Rear Outer Handle: Installation

Before installation, check the following items.
- Lever is free from deformation.
- Grease is applied sufficiently to lever joints.
- If grease is insufficient, add it as necessary before assembling.
Install each part in the reverse order of removal.
CAUTION: Do not reuse the screws of latch & actuator assembly - rear. Always replace with a new part.

Tightening torque:

Refer to "COMPONENT" of "General Description". Ref. to SECURITY AND LOCKS>General Description>COMPONENT>DOOR LOCK ASSEMBLY .
Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .