Rear Gate Latch and Actuator Assembly: Inspection: Actuator

Preparation tool: 

Circuit tester

1. Check door lock operation

   Check the door lock operation when battery voltage is applied between the terminals of actuator.

   Fig 1: Identifying Door Lock Connector Terminals

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions	Specification
   1 (+) - 2 (-)	Connect battery to the terminals	OPEN

2. Check switch

   Check the resistance between actuator terminals.

   Terminal No.	Inspection conditions	Specification
   3 - 4	OPEN	Less than 1.5 Ω
   	CLOSE	1 MΩ or more

3. If it does not operate properly as a result of inspection, replace the latch and actuator - rear gate.