Push Button Ignition Switch: Inspection

Preparation tool 

Circuit tester

1. Check the continuity between push button ignition switch terminals.
   Fig 1: Identifying Push Button Ignition Switch Connector Terminals

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions	Specification
   4 (COM) - 5 (GND)	Always	Continuity exists
   7 (SSW1) - 5 (GND)	Push button ignition switch released → pressed	Continuity exists
   2 (SSW2) - 5 (GND)	Push button ignition switch released → pressed	Continuity exists

2. Check the push button ignition switch operation when battery voltage is applied between the terminals of the push button ignition switch.

   Terminal No.	Inspection conditions	Specification
   11 (SWIL) - 5 (GND)	Connect battery to the terminals	Goes off → Red switch illumination light
   12 (INDS) - 5 (GND)		Turns off → Switch indicator lights in green
   13 (INDW) - 5 (GND)		Turns off → Switch indicator lights in orange

3. Replace the push button ignition switch if the inspection result is not within the standard value.