Check Hazard Light Operation

CHECK HAZARD LIGHT OPERATION .
Make sure the hazard light blinks when hazard switch is turned to ON.

Does the hazard light blink?
1. Yes: Go to 2 .
2. No: Check the hazard light circuit.
CHECK BODY INTEGRATED UNIT SETTING .
Display the [Hazard answer-back setup] data using Subaru Select Monitor.

NOTE: For detailed operation procedures, refer to "Application help".

Is the setting ON?
1. Yes: Go to 3 .
2. No: Turn the setting to ON.
CHECK DATA MONITOR .
Display the data of Hazard Output using Subaru Select Monitor.

Is output signal present when operating the transmitter LOCK/UNLOCK button?
1. Yes: Go to 4 .
2. No: Go to 5.
CHECK KEYLESS ENTRY OPERATION .
Press the LOCK/UNLOCK button of the keyless transmitter.

Does it operate properly?
1. Yes: Replace the body integrated unit. Ref. to SECURITY AND LOCKS>Body Integrated Unit .
2. No: Check keyless entry system. Ref. to SECURITY AND LOCKS>Keyless Entry System>INSPECTION>SYMPTOM CHART .
CHECK HAZARD LIGHT CIRCUIT .
1. Disconnect the connectors of the body integrated unit and turn signal & hazard unit.
2. Check the harness between body integrated unit and turn signal & hazard unit.
  Connector & terminal
  
  (i171) No. 18 - (B32) No. 8:
Is harness normal?
1. Yes: Check body integrated unit. Ref. to BODY CONTROL(DIAGNOSTICS)>Basic Diagnostic Procedure .
2. No: Repair or replace the harness.