Model Without Keyless Access With Push Button Start

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>NOTE>BATTERY .
   NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
2. Remove the cover assembly - column.
   1. Remove the screws by turning the steering wheel to right and left.
   2. Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
   Fig 1: Removing Cover Assembly - Column

   Courtesy of SUBARU OF AMERICA, INC.
3. Remove the immobilizer antenna assembly.
   1. Disconnect the connector.
   2. Release two claws using a flat tip screwdriver or similar tool wrapped with a protection tape, and remove the immobilizer antenna assembly.
      CAUTION: Do not apply excessive force to disengage the lock of immobilizer antenna assembly. Otherwise they may be broken because those parts are the products made of a plastic.

Fig 2: Releasing Claws Using Flat Tip Screwdriver

Courtesy of SUBARU OF AMERICA, INC.