Ignition Key Lock: Inspection

Preparation tool: 

Circuit tester

1. Check the resistance between switch terminals.
   Fig 1: Checking Ignition Key Lock Switch Terminals Angle

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions		Standard
   Between all terminals	(A)	LOCK	1 MΩ or more
   2 - 4	B)	ACC	Less than 1 Ω
   1 - 2 - 4 5 - 6	(C)	{ON}	Less than 1 Ω
   1 - 3 - 4 5 - 6 - 7	(D)	ST	Less than 1 Ω

2. Replace the ignition switch assembly if the inspection result is not within the standard.