MODELS WITHOUT EyeSight

NOTE: Since the arm assembly - windshield wiper LH and RH can interfere with each other, install the passenger's side first.

Install the arm assembly - windshield wiper.
1. Assemble the arm assembly - windshield wiper so that the blade assembly - windshield wiper is aligned to the ceramic print point mark of the windshield glass.
  
  Fig 1: Checking Windshield Wiper Aligned To Ceramic Print Point Mark
  Courtesy of SUBARU OF AMERICA, INC.
2. Tighten the arm assembly - windshield wiper to specified torque and install the cap.
Tightening torque:

26 N.m (2.65 kgf-m, 19.2 ft-lb)
Operate the windshield wiper to check that the stop position is aligned with the point mark. If it is not aligned with the point mark, perform the removal and installation of the windshield wiper over. Ref. to WIPER AND WASHER SYSTEMS>Front Wiper Arm>REMOVAL .