LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Front Washer Nozzle and Hose >> Removal >> Nozzle - Windshield Washer & Hose

Nozzle - Windshield Washer & Hose

  1. Remove the arm assembly - windshield wiper. Ref. to WIPER AND WASHER SYSTEMS>Front Wiper Arm>REMOVAL .
  2. Remove the cowl panel side and cowl panel assembly. Ref. to EXTERIOR/INTERIOR TRIM>Cowl Panel>REMOVAL .
    CAUTION: Before removing the cowl panel, use an air blower and nylon brush to sweep gravel from the lower area of the front side of the glass.
  3. Remove the nozzle - windshield washer.
    1. Push the claw using a flat tip screwdriver, etc.
    2. When the nozzle - windshield washer lifts up, pull out the nozzle - windshield washer using a clip remover, etc.
    3. Disconnect the hose - windshield washer, and remove the nozzle - windshield washer.
    Fig 1: Pushing Claw Using Flat Tip Screwdriver
    G08316561Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the hose - windshield washer & hose as necessary.
Fig 2: Locating Windshield Washer Hose (Models Without Eyesight)
G11268612Courtesy of SUBARU OF AMERICA, INC.
Fig 3: Locating Windshield Washer Hose (Models With Eyesight)
G11268613Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals