LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> SRF OFF Switch >> Inspection

SRF OFF Switch: Inspection

  1. Measure the resistance between connector terminals.

    Preparation tool: 

    Circuit tester

    Fig 1: Measuring Resistance Between Connector Terminals
    G10277284Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection conditions Standard
    2 - 3 OFF 1 MΩ or more
    ON Less than 1 Ω
  2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
    Terminal No. Inspection conditions Specification
    1 (+) - 4 (-) Apply battery voltage. Light ON
  3. Replace the SRF OFF switch if it is found defective.
scientia non olet · About LEMON Manuals