Room Light: Removal

NOTE: Do not remove the room light if removing the bulb only.

Disconnect the ground cable from battery. Ref. to NOTE>NOTE>BATTERY .
NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
Remove the light assembly - room.
CAUTION: When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around the tool, and be careful not to cause damage.
1. Release the claws and remove the lens.
2. Remove the screws and pull out the light assembly - room.
  
  Fig 1: Locating Light Assembly - Room Screws
  Courtesy of SUBARU OF AMERICA, INC.
3. Disconnect the connector and remove the light assembly - room and the bulb.
  NOTE: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.

Fig 2: Removing Light Assembly - Room Connector

Courtesy of SUBARU OF AMERICA, INC.