Room Light Switch
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard 1 - 3 Switch OFF 1 MΩ or more Switch ON Less than 1 Ω 2 - 3 Switch door Less than 1 Ω - Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 3 (+) - 1 (-)
3 (+) - 2 (-)Switch OFF Light OFF Switch ON Light ON Switch door Light ON - Replace the light assembly - room if faulty is found in the inspection.