Rear Combination Light Assembly: Inspection

Apply battery voltage between the connector terminals to check the lighting condition of the light.

Fig 1: Applying Battery Voltage Between Connector Terminals

G10317139

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Specification
5 (+) - 6 (-)	Apply battery voltage.	Stop light on
1 (+) - 6 (-)		Tail (parking) light on
2 (+) - 6 (-)		Turn signal light on
3 (+) - 6 (-)		Back-up light on

Replace the harness and bulb if it is found defective.