Inspection Mode 2
| DTC | Item | Note |
|---|---|---|
| B2A04 | MIC CIRCUIT | Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2A04 MIC CIRCUIT . |
| B2A05 | LEFT SPEAKER/AUDIO CIRCUIT | Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT . |
| B2A06 | RIGHT SPEAKER/AUDIO CIRCUIT | Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2A06 RIGHT SPEAKER/AUDIO CIRCUIT . |
| B2A0A | RED LED CIRCUIT | Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2A0A RED LED CIRCUIT . |
| B2A0B | GREEN LED CIRCUIT | Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B2A0B GREEN LED CIRCUIT . |
Inspection steps:
- Clear the memory. Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Clear memory .
- Read the DTC and check that the DTC is not displayed. Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1).
- Turn the ignition switch to OFF.
- Close all doors. (The vehicle enters CAN sleep state.)
- Wait for approx. 1 minute. After the indicator goes off, wait for another 1 minute. (DCM standby mode)
- Turn the ignition switch to ON, and wait for 5 seconds or more.
- Read the DTC and check that the DTC is not displayed.NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.