Telematics Button
- Check the button.
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
- SOS button
Terminal No. Inspection conditions Standard 6 - 1 {OFF} Approx. 1.6 kΩ {ON} Less than 1 Ω - i-button
Terminal No. Inspection conditions Standard 3 - 1 {OFF} Approx. 1.6 kΩ {ON} Less than 1 Ω - SOS button
- Apply battery voltage between the connector terminals to check lighting status of illumination inside the button.
Terminal No. Inspection conditions Specification 8 (+) - 2 (-) Apply battery voltage. Light ON - Measure the resistance between connector terminals.
- Check the indicator.
- Check the continuity between the connector terminals.
Terminal No. Indicator Specification 4 - 1 Green Continuity exists 7 - 1 Red Continuity exists - Replace the overhead console or stereo camera cover assembly if faulty is found in the inspection.