Function Check

AUTO HEADLIGHT BEAM LEVELER SYSTEM
1. Turn the ignition switch to ON.
2. Turn on the headlight low beam.
3. Check that the beam axes move when the vehicle condition is kept for three seconds or more after the vehicle posture is changed with the vehicle stopped.
LED headlight system
1. Turn the ignition switch to ON.
2. Turn on the headlight low beam.
3. Check that the headlight Low beam illuminates with normal brightness.
Steering responsive headlight (the initialize function)
1. Stop the vehicle at approximately 1 m (3.3 ft) away and perpendicular to the wall.
2. Make the vehicle vicinity dark.
3. Set the vehicle headlight switch to Low beam.
4. Make sure that the headlight cut line moves to left and right immediately after the engine started.