LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> SUBARU Eyesight System (Driver Assist) (Diagnostics) >> Real-time Diagnosis >> Operation

Real-time Diagnosis: Operation

  1. On [Start] display, select [Diagnosis].
  2. On [Vehicle selection] display, input the target vehicle information and select [OK].
  3. On [Main Menu] display, select [Each System].
  4. On [Select System] display, select [EyeSight], and then select [Enter].
  5. On [Select Function] display, select [Data monitor].
  6. Check that the display changes and the contents are correct when performing the operations as follows.
    • Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)
      • Item [Brake Lamp SW (BIU)][Brake SW Input][Brake Lamp SW (VDC)]
    • Turn the main switch to ON.
      • Item [Cruise Control SW Voltage (Port14)][Cruise Control SW Voltage (Port16)]
    • Turn the SET/- switch to ON.
      • Item [Cruise Control SW Voltage (Port14)][Cruise Control SW Voltage (Port16)]
    • Turn the RES/+ switch to ON.
      • Item [Cruise Control SW Voltage (Port14)][Cruise Control SW Voltage (Port16)]
    • Turn the "Vehicle distance" switch to ON.
      • Item [Cruise Control SW Voltage (Port14)][Cruise Control SW Voltage (Port16)]
    • Turn the "Lane keep" switch to ON.
      • Item [Cruise Control SW Voltage (Port14)][Cruise Control SW Voltage (Port16)]
    • Operate the shift lever.
      • Item [Current gear position]
    • Press and hold the pre-collision brake OFF switch.
      • Item [Pre-Collision Brake OFF Display Signal]
    • Press and hold the lane departure warning OFF switch.
      • Item [Lane Departure Warning Display Signal]
    NOTE: For detailed operation procedures, refer to "Application help".
scientia non olet · About LEMON Manuals