Inspection Mode 1

DTC	Item	Note
U0073	U0073 U0073 CONTROL MODULE COMMUNICATION BUS OFF	-
U0074	CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF	-
U0100	LOST COMMUNICATION WITH ECM/PCM "A"	-
U0101	LOST COMMUNICATION WITH TCM	-
U0122	LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULE	-
U0140	LOST COMMUNICATION WITH BODY CONTROL MODULE	-
U0155	LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULE	-
U0401	INVALID DATA RECEIVED FROM ECM/PCM "A"	-
U0402	INVALID DATA RECEIVED FROM TCM	-
U0416	INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULE	-
U0422	INVALID DATA RECEIVED FROM BODY CONTROL MODULE	-
U0423	INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULE	-
B2304	REAR RADAR ON-OFF SWITCH STUCK	-
B2311	REAR RADAR DETECT TCM	-
B2313	REAR RADAR DETECT VDC	-
B2327	REAR RADAR INTERNAL FAILURE (INTERNAL ELECTRIC CIRCUIT)	-
B2350	REAR RADAR COMMUNICATION ERROR BETWEEN MASTER AND SLAVE	-

Clear the memory. Ref. to Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS)>Clear memory .
Read the DTC and check that the DTC is not displayed. Ref. to Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .
NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1).
Start the engine and wait for 30 seconds or more.
Read the DTC and check that the DTC is not displayed.
NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. Ref. to Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC) .