Diagnostic Trouble Code (DTC): Operation

On [Start] display, select [Diagnosis].
On [Vehicle selection] display, input the target vehicle information and select [OK].
On [Main Menu] display, select [Each System].
On [Select System] display, select [Blind Spot Detection/Rear Cross Traffic Alert(RH)] or [Subaru Rear Vehicle Detection(LH)], and then select [Enter].
On [Select Function] display, select [DTC].
NOTE:
- For detailed operation procedures, refer to "Application help".
- For details concerning DTC, refer to the List of Diagnostic Trouble Codes (DTC). Ref. to Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC) .
- Check and replace the side that displayed the DTC.