[S], [I] Or [S#] Indicator Is Blinking
- CHECK DTC (CURRENT MALFUNCTION).
Read DTC of engine and combination meter. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Read Diagnostic Trouble Code (DTC) . Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Read Diagnostic Trouble Code (DTC) . Ref. to COMBINATION METER (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .
Are any DTCs displayed?
- Yes : Perform the diagnosis for the displayed DTCs.
- No : Go to 2.
- CHECK DTC (CURRENT MALFUNCTION).
- Start the engine.
- Read all DTCs. Ref. to LAN SYSTEM (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .
Is DTC U**** displayed?
- Yes : Perform the diagnosis according to the basic diagnostic procedure in LAN SYSTEM (DIAGNOSTICS). Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure .
- No : Go to 3.
- CHECK THE ENGINE COOLANT TEMPERATURE LIGHT.
Connect the Subaru Select Monitor, and perform forced operation of the SI-DRIVE indication with [Active Test] for the combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>Active Test .
Do the indicated amount on Subaru Select Monitor and the SI-DRIVE indication match?
- Yes : Check the engine. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Basic Diagnostic Procedure . Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Basic Diagnostic Procedure .
- No : Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .