Related Lines 53 - 61 Ω (Remote Engine Starter): Wiring diagram

CAN communication system Ref. to WIRING SYSTEM>CAN Communication System>WIRING DIAGRAM .

• Non-turbo model

Fig 1: Remote Engine Starter System Wiring Diagram Non-Turbo Model (1 Of 2)

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Remote Engine Starter System Wiring Diagram Non-Turbo Model (2 Of 2)

Courtesy of SUBARU OF AMERICA, INC.

Fig 3: Remote Engine Starter System Wiring Diagram Turbo Model (1 Of 2)

Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Remote Engine Starter System Wiring Diagram Turbo Model (2 Of 2)

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS. 
   1. Disconnect the remote engine start Control Module connector.
   2. Using the tester, measure the resistance between terminals.

      Connector & terminal 

      Without push button start 

      (B180) No. 1 - (B180) No. 2:

      With push button start 

      (B180) No. 2 - (B180) No. 3:

   Is the resistance 400 Ω or more?

   • Yes  : Related lines between remote engine start Control Module and main wiring harness is open, or main wiring harness is open at two places or more.
   • No  : Go to 2. 
2. CHECK RELATED LINES. 

   Using the tester, measure the resistance between terminals.

   Connector & terminal 

   Without push button start 

   (B180) No. 1 - (B40) No. 6:

   (B180) No. 2 - (B40) No. 14:

   With push button start 

   (B180) No. 2 - (B40) No. 6:

   (B180) No. 3 - (B40) No. 14:

   Is the resistance 10 Ω or more?

   • Yes  : Repair or replace the open circuit of remote engine start Control Module related lines.
   • No  : The communication harness is normal. Check the remote engine starter Control Module or the mobile key.